I installed RMC 9 on my Vista machine about 1 month ago. Everything was working fine. I was able to use all the sub programs like disk copy, creator classic etc. Now out of no where the program are very slow to load and becomes unresponsive for few seconds. When I try to click on something I get a vista error

" Creator is not responding.....End or waite...."


After a bit the programs responds. Same thing happens again when you click the next button. Any ideas?

In general, if a program which worked suddenly dercides to stop, you should look at anything else that may have been added round the time the problem appeared.

I take it you did do an anti-virus and malware sweep?

Also, if you can, post your system specs (similar to my signature) - mainly CPU, RAM and graphics

I haven't ran virus scan or anti-spam software nor have I installed any software.

Then you should do both, along with a defrag of your hard drive.