I put the disc in and i put in my code and it will start installing all the way to the end and it will say "Please insert the disc". Anyone know what I can do to fix this?????

If you did a custom or a full install, it's probably looking for the second (content) disc

I put the other disc in and it said the samething. Then I put back in the program disc and still say the samething (Please insert the disc).



Please help

Check that the disc isn't dirty (thumbprints, gunk stuck to it (the gunk has been known to happen). Also, try to copy the contents over to a folder anywhere on the hard drive and run setup.exe from there in case the lens is dirty and the laser isn't reading the disc fully

If it won't copy over you may have a faulty disc

I checked the disc for anything at all, and didn't see anything. Now how do i copy the contents over to a folder??

Thanx for your help

Make a folder on your hard drive, put your disk in the drive, and copy the files, the same way that you would copy files from one place on your computer to another.

Thanx for your help I am copy the files right now and then I will try to install when it finish's... I will let u know if it works.


Thanks alot

I hope that it goes well for you.

I just finished and it all worked well thank you all very much this has been a problem for about a 1 1/2...

Thank u all
Have a good day!!!!!!!!!!!!

You are weelcome, and I am glad that it worked. The credit goes to Daithi.