I know that Drag to Disc is interfering with all of my disc drives. I have 5 computers and all are affected the same way. When no EMC is present they work fine. I have tried to custom install and leave Drag to Disc out and it still installs, and to disable it, (well you can forget it). I cannot disable or stop it from taking over the Disc Drives. I cannot play Audio CD's, DVD Movies, load or install programs because Drag to Disc restrains the Drives and strangles them. If I cannot get any reasonable solution to this problem, Roxio and Sonic will lose me as a Customer. (I know that is no big loss for them, because I am one voice, one vote. Signed Billy

It's possible there are remnants of D2D left after an earlier installation. I have installed it on many occasions and succeeded in stopping D2D from cropping up.
That said, it shouldn't 'grab' any drive unless you have a formatted disc installed.

However, try the clean install procedure and then do the custom install after

http://kb.roxio.com/search.aspx?URL=/conte...S=set-locale=en

I know it says EMC9/10 but it should work

Just as a FYI - D2D was dropped after EMC9

Oh it isn’t really that hard…

Start – All Programs – Start Up – delete Drag to Disc.

Next time you boot, it will no longer run.

Or Add/Remove Programs and use Modify to remove it:

Click to view attachment

This is from V7 but it works the same up through V9

Thanks for the Replies, will try all tonite and see if I correct the problem. Thank You again!