2 replies to this topic

[Atomicgal]

I keep getting this same error and I need a little help.  I get this error when I try to burn a disc or create a disc image.

internal software error: .\vobulator\BlockPlanner\BlockPlanner.cpp,line 234 -2 Found PG with no video



1st - the DVD functions perfectly in simulation mode.  
Everything plays and the disc is not full.  I still have over 1 gig left before a disc would be full.
I checked all my menus and titles and there are no chapter points outside the end of a clip etc...
I figure the PG with no video means that I have a command like a chapter point that is pointing to something that does not exist.

[SS Scott]

I have had one user comment on this in the past.  He seemed to indicate that the cause was trim at the front of the video clip and a trim at the end of the video clip and a chapter point very near the end.  So, likely that if you get rid of or shorten your trims or eliminate the chapter point at the end of the timeline, you will burn properly.

[jdoc6]

I got this error with MyDVD 5.3.  It appeared to be caused by multiple chapter points at virtually the same point in the timeline (with no appreciable video in between).  Getting rid of redundant chapter points seemed to correct the problem, and allow the DVD to be created properly.  (So it sounds like the error occurs when a chapter has no appreciable video uniquely associated with it, whether in the middle or at the start/end.)