[dsldude]

I recently installed the 10.1 version of EMC10. Everything went well, until I went to print and reprint a couple of Labels. After doing a lot of reading on these forums, I understand that 10.1 will not read/open previously created JWL files. Is there a solution to that?

Also, I have a lightscribe drive, but do not want to use it as the default "Printer" in Label Creator. Every time I select print, the program automatically jumps to that selection. I have to wait for it to generate the preview, before I can change to my inkjet. Is there a way to set the Inkjet as the primary printer?

Any suggestions, heartfully accepted...

Thanks

[Jim_Hardin]

Fix? No

I thought that it defaulted to the printer used in the last project? If it is set to print a disc, it probably will default to LightScribe. But I was wrong!!!

This post has been edited by Jim_Hardin: 25 February 2009 - 09:11 AM

[dsldude]

I am guessing that I will have to disable the Lightscribe function so that I can print my labels..

I agree

Regarding the JWL cases, one would have thought that they might come out with a fix for that.

Thanks

[grandpabruce]

I am guessing that I will have to disable the Lightscribe function so that I can print my labels..

I agree

Regarding the JWL cases, one would have thought that they might come out with a fix for that.

Thanks

It may be possible that Roxio will come out with a fix, but the problem carried over into Creator 2009.