In EMC8 one could drag Transitions into the box between photos while the Transition selection remained open. I'm new to EMC9 but I find I need to open "Add Transitions", select one, Click OK, tell it where to insert it (before panel, after panel, replace etc), Click OK and then the Transition selector SHUTS DOWN !!! Then I have to start from scratch for the next transition.
I have 240 transitions to insert. Is there a way to drag and drop or at the very least keep the Transition box open so I don't have to load each time?
Thanks -
To Whomever Was About to Help Me -
I found that if I open "Effects Selector" and choose Transitions, I can drap and drop from there.
Question
SRM2007
In EMC8 one could drag Transitions into the box between photos while the Transition selection remained open. I'm new to EMC9 but I find I need to open "Add Transitions", select one, Click OK, tell it where to insert it (before panel, after panel, replace etc), Click OK and then the Transition selector SHUTS DOWN !!! Then I have to start from scratch for the next transition.
I have 240 transitions to insert. Is there a way to drag and drop or at the very least keep the Transition box open so I don't have to load each time?
Thanks -
To Whomever Was About to Help Me -
I found that if I open "Effects Selector" and choose Transitions, I can drap and drop from there.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.