Jump to content
  • Who's Online   0 Members, 0 Anonymous, 18 Guests (See full list)

    • There are no registered users currently online
  • 0

After install drives not recognised as burnable


A Zannder

Question

Greetings,

I have installed EMC9 on my system (specs below) and have run into a rather strange problem. Most of the EMC9 programs will not recognise either drive as a device that can burn a disk. The D2D program has no problems buring to either device, and the DVDInfo program recognises both as being CD/DVD recorders/re-writers.

I have looked through many of the threads on this forum and have not found any issues exactly the same. I did follow the directions for many that were similar, but to no avail. Any help would be apprecieated.

 

 

Specs: (from device manager)

 

  • CPU: Mobile AMD Athlon XP-M Processor 2800+ 1.88ghz
  • RAM: 1GB
  • Video: Radeon 9000 dual head, most current drivers
  • CD/DVD Drives: (both on secondary IDE)
    • (Master) Lite-on DVDRW SOHW-16936 (Firmware unknown)
       
    • (slave) Lite-on LTR-16102B (Firmware unknown)

    [*]2 HDD: (both on Primary IDE)

    • (Master) WDC WD400BB-60BNA1
       
    • (Slave) WDC WD800BB-00CAA0

    [*]Audio: RealTek AC'97 Audio

Link to comment
Share on other sites

5 answers to this question

Recommended Posts

Are the drives seen in device manager? Are there any yellow exclamation marks by them?

 

Uninstall the secondary IDE channel, reboot and try them.

 

cd

 

 

After re-installing XP and getting the newest driver... I had to step back 1 driver level, and now it works.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...