Label and insert alignment

[RollingT]

I am trying to print CD disc labels and jewel case insets. They do not align on either Avery or Memorex stock. Can anyone help with this.

 

Thanks!

[RollingT]

Did you check on Print properties for your paper stock?

 

It should be there under 'commercial'

 

 

Did you check on Print properties for your paper stock?

 

It should be there under 'commercial'

 

Yes. I chose the label number and with Avery the labels print about 0.25 in. off center. With Memorex and trying to print front and back inserts the back works ok but the front prints almost on the left margin. If I try the slimline insert it is way off also.

[gi7omy]

I haven't used 8 for a while, but if memory serves, there should be a manual adjustment to allow you to alter the vertical and horizontal offset (sort of fine tuning).

 

Experiment with that on a sheet of plain paper (use an old label stock as a template, hold that over the plain sheet and you will be able to see the outline - a lot cheaper than using label stock)

[rich86]

I am trying to print CD disc labels and jewel case insets. They do not align on either Avery or Memorex stock. Can anyone help with this.

 

Thanks!

 

After performing the "page setup" and choosing commercial paper and selecting the exact paper brand & form# you are trying to print to - try setting "preferences" and/or "calibrate" before printing.

[gi7omy]

Did you check on Print properties for your paper stock?

 

It should be there under 'commercial'