Roxio won't load after installing McAfee Security Center

[LutherLee]

After attemping to start Roxio Creator 9 following an installation of McAfee Security Center, the program starts to load then I receive an error that states...

 

"All your drives are set to disabled. On this operating system, in order to start Roxio Creater 9 Home you must either physically remove your drive(s) or enable at least one drive"

 

my system is a home build.

ASUS M2NPV-VM motherboard

AMD 64 4000

2gig memory

3 250 gig seagate hard drives

XFX 256 graphics card

Lite-on CD/DVD RW

Windows XP Pro SP2

 

 

Any suggestions would be appreciated.

[Beerman]

After attemping to start Roxio Creator 9 following an installation of McAfee Security Center, the program starts to load then I receive an error that states...

 

"All your drives are set to disabled. On this operating system, in order to start Roxio Creater 9 Home you must either physically remove your drive(s) or enable at least one drive"

 

my system is a home build.

ASUS M2NPV-VM motherboard

AMD 64 4000

2gig memory

3 250 gig seagate hard drives

XFX 256 graphics card

Lite-on CD/DVD RW

Windows XP Pro SP2

Any suggestions would be appreciated.

 

You should disable any antivirus/spyware before installing EMC9. McAfee Security has caused problems with lots of software.

[LutherLee]

You should disable any antivirus/spyware before installing EMC9. McAfee Security has caused problems with lots of software.

 

 

EMC9 was installed Before installing McAfee Security Center.

[Beerman]

EMC9 was installed Before installing McAfee Security Center.

Have you turned off the Security Center and tried starting EMC? I'm not very familiar with it but you can tweak the settings to allow certain programs 100% access.

That is a rather curious error message....I must admit.