Paper stock - Label Printing

[Humanahum]

I am so used to using the Nero label creator and I have just come up with a complete blank! I have a few packs of labels that I would like to use up, they are not on the list of predefined labels so I was wondering how I go about adding my own paper stock and entering the dimentions manually for the labels. Hope someone can help because otherwise I think I am going to like the Roxio label designer.

Thanks everyone in advance

Adam

[gi7omy]

There is a calibration setting - what I do is to prnt out a dummy label on a standard piece of paper and then hold that behind a used label sheet - you should be able to see the printed outline through the 'hole' in the CD sheet - check the vertical and horizontal offsets in that (in millimetres) and then set the calibration to correct those

[Humanahum]

Thanks - Although I did try that and it came out a bit wrong! I guess I'll have to keep at it

[gi7omy]

It does involve a LOT of trial and error - been there, done that and turned the air blue

[jeanrosenfeld]

To adjust the position where label creator prints, in the print window click preferences. check fine tuning. type amounts to move (in cm) V +ve number moves print down, -ve number moves print up. H +ve number moves to the right, -ve number moves to the left.