Issues between EMC 10 and Ulead video Studio

[dvpearson]

I use DVDXpressDX2 for my video capture device. EMC 10 does not recognize it so I use Ulead Video Studio SE 9 to capture a video. Then I can work with the "uvs" file from the Roxio application. When I begin to burn the DVD using MyDVD in Roxio sometimes Roxio will hang or it will burn and then hang. I am sure that it is being caused by an issue between Roxio and Ulead. Is there an easier work-around? Is Roxio working on a patch to recognize DVDXpressDX2?

[perplext]

I use DVDXpressDX2 for my video capture device. EMC 10 does not recognize it so I use Ulead Video Studio SE 9 to capture a video. Then I can work with the "uvs" file from the Roxio application. When I begin to burn the DVD using MyDVD in Roxio sometimes Roxio will hang or it will burn and then hang. I am sure that it is being caused by an issue between Roxio and Ulead. Is there an easier work-around? Is Roxio working on a patch to recognize DVDXpressDX2?

 

Thanks for this information. Does removal of Ulead allow the use of Creator 10 for video capture or is the problem elsewhere?

[ggrussell]

Don't think it is the file. I also have Ulead Studio 10 and have used files captured by it with no problems. Most likely another issue.

 

Did you do any editing? Did you add any 3D transitions? A bit more information would help.

[dvpearson]

Don't think it is the file. I also have Ulead Studio 10 and have used files captured by it with no problems. Most likely another issue.

 

Did you do any editing? Did you add any 3D transitions? A bit more information would help.

 

 

Thanks for the reply. I did not do any editing or adding anything to the Ulead Video File. Roxio handled it fine. There was no problem with the file. I think there is an issue between EMC 10 and Ulead when both are on my computer and I have used Ulead before using Roxio. It only happens with the DVD tools. The other Roxio tools work fine.

[ggrussell]

I can assure you - at least on my machine - there is no conflict. I can even run them at the same time. Ulead creates standard DV AVI Type 1 and Type 2 captures.

 

Set video render to software and see if that helps.

Open MyDVD

Load your project

Click on TOOLS / OPTIONS

Then click on SOFTWARE so there is a 'dot' beside it.

Click OK and then try rendering your project.

[dvpearson]

I can assure you - at least on my machine - there is no conflict. I can even run them at the same time. Ulead creates standard DV AVI Type 1 and Type 2 captures.

 

Set video render to software and see if that helps.

Open MyDVD

Load your project

Click on TOOLS / OPTIONS

Then click on SOFTWARE so there is a 'dot' beside it.

Click OK and then try rendering your project.

 

Your suggestion was the solution. I captured a video with Ulead and processed it with EMC10. Thanks for the help