Opening Emc10? Keeps Sticking!

[dodgecrib]

I been having a problem with my EMC10. Most of the time when I try to open it,,,it will get stuck on the screen with the pictures and title and will just stay there until I restart or right click on it to close it. This is driving me nuts!!!!

I even try to open what I want specifically like(creator classic) by going into programs and the correct screen will come up but the vista rolling circle keeps going and going!

 

The only way I can usually get it to open is to restart. Somethings not right!!

 

Any ideas?

 

Thanks, BILL

[Jim_Hardin]

Could it be cause I also have EMC9 still installed??

No…

 

Do the Clean Install.

 

[grandpabruce]

I been having a problem with my EMC10. Most of the time when I try to open it,,,it will get stuck on the screen with the pictures and title and will just stay there until I restart or right click on it to close it. This is driving me nuts!!!!

I even try to open what I want specifically like(creator classic) by going into programs and the correct screen will come up but the vista rolling circle keeps going and going!

 

The only way I can usually get it to open is to restart. Somethings not right!!

 

Any ideas?

 

Thanks, BILL

 

 

Did you get your problems squared away in this thread?

 

http://forums.support.roxio.com/index.php?...mp;#entry220223

 

You may be having problems with your video card/chip. List your system specs, similar to how I have mine listed in my signature. The video card/chip is of prime importance.

[dodgecrib]

Did you get your problems squared away in this thread?

 

http://forums.support.roxio.com/index.php?...mp;#entry220223

 

You may be having problems with your video card/chip. List your system specs, similar to how I have mine listed in my signature. The video card/chip is of prime importance.

Yes I got that problem fixed by switching the (software,harware) rendering like it was suggested.

 

BILL

HP 2.40 Intl quad core 3GB

GForce 7350LE

[Jim_Hardin]

Then you should follow the Clean Install procedures –

Here

[dodgecrib]

Then you should follow the Clean Install procedures –

Here

 

 

Could it be cause I also have EMC9 still installed??