Jersey girl 57 Posted April 26, 2009 Report Share Posted April 26, 2009 Hi After reading all the helpful posts and doing a clean install I managed to load CD1 of Creator 2009 Ultimate. This seems to be fine, but I cannot load CD2 Any Ideas? Thanks in advance Link to comment Share on other sites More sharing options...
Jim_Hardin Posted April 26, 2009 Report Share Posted April 26, 2009 What happens? Link to comment Share on other sites More sharing options...
Jersey girl 57 Posted April 26, 2009 Author Report Share Posted April 26, 2009 What happens? I get a request to go to windows XP to configure system requirements. When I do that I get a notice that my drive door may not be closed or there is no CD in the drive. Any good Ideas? Link to comment Share on other sites More sharing options...
Jim_Hardin Posted April 26, 2009 Report Share Posted April 26, 2009 Haven’t had a “good idea” in ages… Try copying the disc to your HD and running Setup from there. If that too fails, might be time to bite down on something and do the Clean Install listed in the pinned post at the top of this forum. Keep us posted! Link to comment Share on other sites More sharing options...
grandpabruce Posted April 26, 2009 Report Share Posted April 26, 2009 I get a request to go to windows XP to configure system requirements. When I do that I get a notice that my drive door may not be closed or there is no CD in the drive. Any good Ideas? Did you reboot, after installing the first disc? Link to comment Share on other sites More sharing options...
Question
Jersey girl 57
Hi After reading all the helpful posts and doing a clean install I managed to load CD1 of Creator 2009 Ultimate. This seems to be fine, but I cannot load CD2
Any Ideas?
Thanks in advance
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.