Delays Opening Production in Creator 2010

[TCT]

Recently upgraded to Windows 7 and then installed Creator 2010. All seems to be working OK BUT I am having incredibly long delays when asking Roxio Videowave to open an existing production. In 1 case, it will not even open the production, it just hangs up.

 

I still have EMC-10 installed so I ran a comparison. With EMC-10, the specific production (.dmsm) file opens in about 40 seconds. Using the same production file in Creator 2010 Videowave, it takes a full 3 minutes to open the file.

 

Anyone know what I have done wrong to cause such long delays? Have I set something up in error? Why so long in Creator 2010 vs EMC-10?

 

With regard to the production that would not open . . . . . . this is a problem with both EMC-10 and Creator 2010. Smells like something about the Windows 7 upgrade must have impacted this production file. I was able to work around the problem by creating a new production with the exact content and the new production works OK now, with either application.

 

Thanks for any help our guidance that anyone can provide.

[bimicher]

Recently upgraded to Windows 7 and then installed Creator 2010. All seems to be working OK BUT I am having incredibly long delays when asking Roxio Videowave to open an existing production. In 1 case, it will not even open the production, it just hangs up.

 

I still have EMC-10 installed so I ran a comparison. With EMC-10, the specific production (.dmsm) file opens in about 40 seconds. Using the same production file in Creator 2010 Videowave, it takes a full 3 minutes to open the file.

 

Anyone know what I have done wrong to cause such long delays? Have I set something up in error? Why so long in Creator 2010 vs EMC-10?

 

With regard to the production that would not open . . . . . . this is a problem with both EMC-10 and Creator 2010. Smells like something about the Windows 7 upgrade must have impacted this production file. I was able to work around the problem by creating a new production with the exact content and the new production works OK now, with either application.

 

Thanks for any help our guidance that anyone can provide.

 

I don't think this has anything to do with W7 since I also have some problems opening EMC 10 projects in C2010 and I am using Vista 64.

Project files from earlier versions are not guaranteed to work with newer versions if they work at all. I have found its much better to either finish the project in the old version or redo it in C2010.

 

I have boteh EMC 10 and C2010 installed and the both work fine.