Roxio 9 used to run on my laptop, recently I had to crash my laptop and reformat the hard drive. I used the toshiba restore to configure my computer as when it was purchased. I loaded from disk the creator 2009 ant it appeared to install correctly. When I try to run the progam I get a Roxio emblem in red on the screen and then it stops running. it does not interfere with any programs or crash the computer or even give an error code. It just acts like nothing got loaded. I installed the sp4, but it still acts the same
Question
edtrev
Roxio 9 used to run on my laptop, recently I had to crash my laptop and reformat the hard drive. I used the toshiba restore to configure my computer as when it was purchased. I loaded from disk the creator 2009 ant it appeared to install correctly. When I try to run the progam I get a Roxio emblem in red on the screen and then it stops running. it does not interfere with any programs or crash the computer or even give an error code. It just acts like nothing got loaded. I installed the sp4, but it still acts the same
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.