000D Install Problems

[NealW]

Hello,

 

I am still trying to intermittently get Creator 2011 to run. Reference my previous discussions on program crashes. To make a long story short, i have trying to get videowave in the edit video mode to load mov files. I have had many discussions with Roxio with no luck. Fortunately I am stil using EMC 9 which does not have a problem with mov files. I loaded 2011 on my laptop and took it off the desktop, so I could finish some projects on the desktop using EMC9. I had no success in geting mov files to work on the laptop either and after trying to load them several times, it no longer would load mpeg2 video files. Every time I would try the program would freeze. There was no problem loading avi files or jpeg. Roxio had me load every alternate codec in the book but no luck. I finished up my projects on the desktop and took off EMC9 using Revouninstaller. I made sure all temp files were deleted all the registry entries and the Sonic and Roxio folders. Now when I try to install Creator 2011 on the desktop I get a 000D error and the program stops loading. Any one have an idea what this is.

 

Thanks,

 

Desktop

HP Pavilion a1630n

AMD Athalon 4600 Dual core 2.41Mhz

4gb mem

Nvidia GeForce 7300 GT display card

250gb harddrive (defragged)

Windows XP media center version 2002, SP3

 

PS, I loaded EMC9 on the laptop ( Compaq CQ60-214DX, 160gbhd, Mobile Intel4 graphics media accelerator, INtel T3400 2.16 dual processor, 2gb mem, Vista sp2,) and it works great reads mov, mpeg and avi with no problem.

[cdanteek]

I get a 000D error

 

Is a reading from the disc error, is that what you are doing?

[NealW]

Hello, thanks for your response. I checked the event log for windows and saw that roxio cineplayer was causing a 016 error. I checked further and found cineplayer files still on the harddrive. Did another clean and was able to load Creator 2011. I am now back to same problem again of not being able to load a mov file in videowave. Back to square one, but with EMC9 on the laptop I can get all my projects done and fool around on this desktop trying to get Creator 2011 to work.

[cdanteek]

Hello, thanks for your response. I checked the event log for windows and saw that roxio cineplayer was causing a 016 error. I checked further and found cineplayer files still on the harddrive. Did another clean and was able to load Creator 2011. I am now back to same problem again of not being able to load a mov file in videowave. Back to square one, but with EMC9 on the laptop I can get all my projects done and fool around on this desktop trying to get Creator 2011 to work.

 

OK...