dr_heckyl Posted September 11, 2011 Report Share Posted September 11, 2011 Howdy I have Win 7 32 bit. I have installed the software and rebooted. When I try to launch it, i get "Roxio Easy VHS to DVD has encountered a user-defined breakpoint". I am running the software as administrator. I have repaired the install several times. It actually worked once I was able to register it, but it is doing it again. Ideas? Link to comment Share on other sites More sharing options...
Jim_Hardin Posted September 11, 2011 Report Share Posted September 11, 2011 First I have ever heard of it, but searching reveals that the error message has been around for years Best thing I can think of is to use the Revo uninstaller, in Moderate mode, to remove V2D. Then do the Prep Steps to the letter! And lastly, install V2D again. I am hoping this will clear up and repair or replace whatever is getting in the way... Link to comment Share on other sites More sharing options...
vonb184e Posted July 6, 2014 Report Share Posted July 6, 2014 Hello, i'm getting the exact message after installing (uninstall/re-install) except I don't get the debug option. Your link for "Prep Steps" didn't give me any help. Couldn't find "Prep Steps". Any recommendation? Link to comment Share on other sites More sharing options...
ogdens Posted July 6, 2014 Report Share Posted July 6, 2014 Go here for the "preparing your Computer for Installing Roxio products" . http://corel.force.c...=new&source=kba Link to comment Share on other sites More sharing options...
Jim_Hardin Posted July 7, 2014 Report Share Posted July 7, 2014 Hello, i'm getting the exact message after installing (uninstall/re-install) except I don't get the debug option. Your link for "Prep Steps" didn't give me any help. Couldn't find "Prep Steps". Any recommendation? Note the DATE of the postings??? These were here Before your version was even written Makes sense that a solution would not apply to you Link to comment Share on other sites More sharing options...
Question
dr_heckyl
Howdy
I have Win 7 32 bit.
I have installed the software and rebooted. When I try to launch it, i get "Roxio Easy VHS to DVD has encountered a user-defined breakpoint".
I am running the software as administrator.
I have repaired the install several times. It actually worked once I was able to register it, but it is doing it again.
Ideas?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.