Jump to content
  • Who's Online   0 Members, 0 Anonymous, 12 Guests (See full list)

    • There are no registered users currently online

Unimodem Driver And Sound Editor


baha132

Recommended Posts

I need some help. I have been using Easy CD & DVD Creator 6 to convert my very large vinyl LP collection to CDs. I just got a new computer and I'm having problems setting the recording level. In the Sound Editor under "Tools" if I choose "Default Mapper Device" for the "Recording Device" I can't set the recording level. If I set the "Recording Device" to "Audio Rear Input" like I want to, I can set the recording level, but the microphone is unselectable and I can't enable recording.

 

I found an article in the roxio knowlegebase (EE60000014) that tells me how to resolve the problem by disabling the unimodem driver, but I cannot locate a unimodem driver under the device manager on my computer. Any suggestions how to resolve this problem or find a unimodem driver so I can disable it?

 

I have Windows XP Media Center 2004 Edition

Link to comment
Share on other sites

If you dont have a unimodem installed dont woory about it.

 

I can,t address the settings in the Sound Editor(dont have Version 6) .

 

See if anything here will help:

 

 

There is a difference between which inputs are made available to the soundcard's output, and which one is made available for recording.

Open up the Windows Volume Control utility. (This is usually available by double-clicking the little yellow icon of a loudspeaker in the system tray. If it's not there, go via Start|Programs|Accessories|Multimedia, or perhaps Start|Progams|Accessories|Entertainment). A screen titled "Volume Control" appears. On this screen you will see a selection of inputs. Each one can be individually switched on or off using its "mute" checkbox. All those which are not muted are available for playback through the soundcard's output, and their relative volumes can be controlled using the appropriate sliders. Thus, this screen behaves like a simple mixer, allowing multiple sources to be gathered together for output.

OK, all this is fine, and allows you to pass the input through to the output, but: it doesn't make the unmuted inputs available for recording to hard disk. To do this, select the "Properties" item from the "Options" menu. A screen titled "Properties" will appear. In the box titled "Adjust volume for", there are radio buttons: select the one for Recording. A list of available inputs appears in the box beneath "Show the following volume controls", and you should ensure that all the various inputs you may wish to record are checked in that list. Now press "OK", and the main screen's title changes to "Recording Control". This screen presents the inputs available for recording, and to activate the one you want, check its associated "Select" checkbox. The recording level can be adjusted using the selected input's volume slider; note that you can adjust this while recording (just like you can with the level control on a tape deck). You may also see a simple level meter (like the LEDs on a cassette deck) next to some inputs on some soundcards; whether they appear depends on the particular facilities provided by the soundcard's driver. However, this meter is uncalibrated and most hard disk recording packages are likely to have better metering. Once you have set the required record level, you can close down the Volume Control utility and the settings will remain unchanged (usually).

One further tip. If you're recording anything other than the microphone input, it is a good idea to mute the microphone on the "Volume Control" screen whilst recording, as the microphone input circuitry can add a fair bit of noise on many soundcards.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...