When I setup the program to capture and select the option PAL 720/1080 and then click OK if I go back to the same section to check or change options I find the software has reset itself to NTSC_M.
Does anyone know if this setting is held in a config file e.g. *.ini file or in the registry either under HKLM or HKCU? I could check the file/registry after setting the option in the software to see if did save correctly or reverted to NTSC_M.
Question
madboyo
Has anyone else seen this problem?
When I setup the program to capture and select the option PAL 720/1080 and then click OK if I go back to the same section to check or change options I find the software has reset itself to NTSC_M.
Does anyone know if this setting is held in a config file e.g. *.ini file or in the registry either under HKLM or HKCU? I could check the file/registry after setting the option in the software to see if did save correctly or reverted to NTSC_M.
Software is running on a Win 7 Ultimate PC
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.