Jscope1214 Posted January 8, 2013 Report Share Posted January 8, 2013 I had my roxio hd pro working for a week or so. i unplugged the wires and pluged them back in, and now it says no signal. I have everything in the same places but its not working, any ideas? Link to comment Share on other sites More sharing options...
Jim_Hardin Posted January 8, 2013 Report Share Posted January 8, 2013 Turn off your computer then unplug everything again and very carefully reconnect making sure you are getting it right If something runs for a week it is VERY unlikely it will fail after that! Link to comment Share on other sites More sharing options...
Jscope1214 Posted January 8, 2013 Author Report Share Posted January 8, 2013 Didnt work, still getting the No Signal sign Link to comment Share on other sites More sharing options...
cdanteek Posted January 8, 2013 Report Share Posted January 8, 2013 Didnt work, still getting the No Signal sign Troubleshooting: Why does the status show as “No Signal” in the Capture application? It means Roxio Game Capture HD PRO device can’t detect video signal from the console you connect to. There are a couple of possibilities: The console is not power on Cable connection is not setup properly according to the Getting Started Guide Video source is not supported. For example, if you are connection to a PS3, HDMI signal can’t be detected by Roxio Game Capture HD PRO device due to HDCP (protected video) by Sony. We suggest you to switch to Component (A/V) cable to connect between PS3 and Roxio Game Capture HD PRO. Please follow the instructions of PS3 setup on Getting Started Guide. The capture device or cable could be damaged Link to comment Share on other sites More sharing options...
Jscope1214 Posted January 8, 2013 Author Report Share Posted January 8, 2013 All i did was unplug and plug back in the wires though Link to comment Share on other sites More sharing options...
Jim_Hardin Posted January 9, 2013 Report Share Posted January 9, 2013 You aren't supplying any information, just keep repeating don't work Why don't you get someone to stop over and go over it with you... If it still doesn't work, they can help you describe your system & setup Link to comment Share on other sites More sharing options...
Question
Jscope1214
I had my roxio hd pro working for a week or so. i unplugged the wires and pluged them back in, and now it says no signal. I have everything in the same places but its not working, any ideas?
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.